Accessories
Inside this magic box is the proper amount of Bob Smith CA glue to build one of most any of our kits.
So, you might be thinking, so what's the difference between this and the glue I can get from local hobby shop?
Well...
Click here to find out.
Our OSMW Laser-Cut Servo Mounts have several advantages over other mounts on the market.
A slotted baseplate allows you to attach the mounting beams to perfectly match your servo's case. Each mount fits standard servos down to micro servos (.875”- 1.6” case length).
The thicker beams give your servo's mounting screws more purchase - less chance of stripping out compared to mounts with just a thin 1/8" ply sheet.
It should go without saying, but just to cover ourselves - the servo is NOT included.
Our OSMW Laser-Cut Switch Mounts have several advantages over other mounts on the market.
A slotted baseplate allows you to attach the mounting beams to perfectly match your switch's case. Each mount fits standard switches, heavy-duty switches, and even larger switches that have charging plugs built-in (1" - 1.75" case width).
It should go without saying, but just to cover ourselves - the switch is NOT included.
A replacement set of the pre-bent main gear for our Kaos 60 kit.
Port and Starboard 5/32" main wire gear only.
A replacement set of the pre-bent main gear for our Robinhood 25 kit.
Front and rear 1/8" main wire gear only (assembly required).
This gear will also fit the original World Engines .25 kit, if you happen to need gear for one of those.
Replacement laser-cut pieces to build the same power pod that is included in our Wayfarer kits (pod-only - assembly required).
A replacement set of the pre-bent main gear for our Robinhood 80 kit.
Front and rear 3/16" main wire gear only (assembly required).
A replacement vacuum-formed canopy for our Kaos 60 kit.
Length: 11", width: 2.5", height: 2.25"
Trim the base to suit, wash, then paint with flexible paint (if desired) then attach using canopy glue.
A replacement vacuum-formed canopy for our Fifty-Six kit.
Length: 9", width: 2", height: 2"
Molded in airfoil shape to fit on top of the Fifty-Six wing. Trim the base to suit, wash, then paint with flexible paint (if desired) then attach using canopy glue.
A replacement vacuum-formed canopy for our Comet and Lark kits.
Length: 7", width: 2", height: 2"
Trim the base to suit, wash, then paint with flexible paint (if desired) then attach using canopy glue.
A replacement vacuum-formed canopy for our Mambo kit.
Length: 9", width: 2", height: 2"
Trim the base to suit, wash, then paint with flexible paint (if desired) then attach using canopy glue.
